Showing 7 results for Fereidooni
, D Fereidooni,
Volume 5, Issue 1 (9-2011)
Abstract
Schmidt hammer is used for calculation of joint compressive strength and elasticity modulus of rocks. Today, application of Schmidt hammer is a common method in evaluation of properties of rocks. This method is quick, inexpensive and non-destructive which are benefits of this method. In this regard, different experimental equations proposed by Barton & Choubey (1977), Deere (1960), Keadbinski (1980), Aufmuth (1973) and ISRM (1981) can be employed in order to calculate the Joint Compressive Strength (JCS) of rocks. Due to the importance of this research, new experimental equations are introduced. Using this equations show a very good results in comparison with the results of other researchers. It should be noted that this equations are achieved from 827 records of Schmidt Hammer results from different types of hard rocks such as granite, diorite and hornfels from the Ganjnameh-Shahrestaneh road in Hamedan province, west of Iran.
Davood Fereidooni, Mohammad Hossein Ghobadi,
Volume 9, Issue 2 (9-2015)
Abstract
In order to assess mineralogical composition influence on durability and strength of rocks, four samples of hornfelsic rocks were selected from southern and western parts of the city of Hamedan, west of Iran. These rock samples were subjected to mineralogical, physical and mechanical tests in the laboratory. Also, they were evaluated in 15 cycles of slake-durability testing in different pH of sulfuric acid solutions and XRD analysis. Based on the results, the type and amount of minerals, their density and hardness had an influence on the uniaxial compressive strength and the slake durability index of tested rocks. That means, presence of non-dissolved minerals such as graphite in studied rocks, decreases Unconfined Compressing Strength (UCS) but increases the slake durability index. The results of slake-durability test indicated that weight loss of the samples at initial cycles was found to be higher than the end cycles. Also, in these samples, initial minerals in the fresh samples were not exchanged by secondary minerals such as clay minerals. Therefore Hamedan hornfelsic rocks are approximately resistant when were put under accelerated chemical weathering and degradation in the laboratory and natural chemical weathering.
, Davood Fereidooni,
Volume 10, Issue 4 (Vol. 10, No. 4 Winter 2017 2017)
Abstract
This research focuses on the identification and description of various features of pseudokarst in different parts of Alvand granitic batholith, Hamedan, west of Iran. In the literature, karst features have been presented as specific types of terrain or landscapes with particular characteristics suites of well-known surface and subsurface dissolutional forms. Whereas, pseudokarst refers to non-dissolutional surface or subsurface features and landforms created in different areas such as slopes, coastal lines crushed stone areas, lava tubes and permafrost regions. In this research, a comprehensive field investigation program has been carried out. During the field investigations, the most important features of pseudokarst in Alvand granitic batholith have been recognized and classified. Results show a wide range of pseudokarst features in the Alvand granitic rock masses. These landforms are created by erosion, weathering processes and some holes caused by rock block movements along the rock slopes. Some of the most important forms and features of the pseudokarst in the studied area are consist of tafoni, genama, pseudokarren, talus caves, caves associated with the residual blocks and erosional forms along joints and fractures within the granitic rock masses
Dr. Davood Fereidooni, Dr. Sajeddin Mousavi, Dr. Esmaeil Najafi, Dr. Gholam Reza Khanlari,
Volume 16, Issue 4 (Winter 2022)
Abstract
Assessing and understanding the hydromorphological characteristics are necessary to understand the behavior of a river and its active processes. This is useful for understanding the erosion and sedimentation regime and changing the river path, for making correct engineering and human activities in the river's catchment area. The Gian River, with an average annual discharge of 2.3 m3/s, is one of the tributaries of the Gamasiab River in the Hamedan province. From a geological and hydrogeomorphological point of view, the Gian is a small river. It is fully compatible with the geological structures of the region. The calculation of the sinusoidal coefficient has shown that this river is a meandering river whose wavelength, the amplitude of the oscillation and the width of the meander belt are smaller in the mountainous area than in the plain area The gradient of the river bed is relatively low and it is classified as an erosion and sedimentation river in its different sections. The Gian River has a rocky bed in the mountainous part and an alluvial bed in the plain. The Gian River has a small catchment area, and, according to theGravelius' coefficient, its shape is almost elongated. The catchment elevation of the Gian River is between 1455 and 2700 with a weighted average of 1715.20 m.a.s.l. and its area decreases with the increase in the elevation. The concentration time of the catchment is 4.204 hours. The application of the data and results of the research can be very effective in land use planning, engineering and executive applications to predict river changes and protect engineering structures such as roads, bridges, coastal structures and railways, protect agricultural lands in the region and develop tourism.
Ms. Somayeh Arab-Ameri, Dr. Davood Fereidooni,
Volume 17, Issue 1 (Spring 2023 2023)
Abstract
Ultrasonic wave velocity testing is a non-destructive, economical, simple and rapid method used for determining the physical and engineering properties of rock. This test is based on the velocity of the elastic wave in rocks. The ultrasonic wave velocity of rocks depends on intrinsic and environmental properties such as mineralogical composition, density, porosity, grain size, shape, texture, anisotropy, water content, and temperature of rocks. In this research, 10 different types of building stone, including limestone and granite, were cut into 50 cubic specimens with dimensions of 10Í4Î4 cm, and then they were tested using the Pandit wave velocity testing machine to find the effective parameters on the velocity of the ultrasonic wave should be investigated in them. These parameters include dry unit weight, temperature, type of pore fluid, state of filling material and loading. Based on the obtained results, the correlation between ultrasonic wave velocity and dry unit weight is a direct linear relationship and its relationship with the type of pore fluid condition of the filling material and loading is inverse relationship. In addition, increasing the temperature increases the velocity of the ultrasonic wave. Also, in terms of the type of pore fluid, the lowest value of the wave velocity was obtained in the state saturated with water and the highest value of the wave velocity was obtained in the common salt solution with a concentration of 150%. Regarding the state of the rock pore filling material, the highest velocity value was observed in the frozen filling state and the lowest velocity value was observed in the air filling state. As the load increases, the velocity of the ultrasonic waves decreases in the studied rocks.
Mr. Mehdi Hashemi, Dr Davood Fereidooni,
Volume 17, Issue 2 (Summer 2023)
Abstract
In this research, the durability and deterioration of two historical stone monuments, including the Dashkasan rock temple and the historical stone inscriptions of the Sojas cemetery in the south of Zanjan province, were investigated. For this purpose, two stone block samples were selected from each historical work for laboratory study. Based on the geological investigations, the historical monuments of the Dashkasan rock temple were carved on tuffs of the Karaj Formation. According to the thin section study, the Dashkasan temple rocks composed of the crystal vitric tuff and lithic vitric tuff and the samples of the historical inscriptions of the Sojas cemetery were limestone and very fine-grained sandstone, quartz being the dominant mineral of these rocks. In terms of physical characteristics, the samples studied have medium density and porosity. In terms of durability and deterioration, all four samples were subjected to 15 cycles of the slake durability test in normal water and sodium sulphate solution. The degradation function model and half-life of all four samples were determined and analysed. The results show that all four samples have a lower slake-durability index in sodium sulphate solution than in normal water. Due to the presence of quartz in lime or clay matrix, the samples of historical stone inscriptions from Sojas cemetery have more water absorption and porosity and are more durable, and their half-life is lower than the samples from Dashkasan rock temple.
M.sc. Behrooz Margan, Dr. Davood Fereidooni,
Volume 18, Issue 1 (Spring 2024)
Abstract
In this research, various aspects of the rock burst phenomenon in the Haji-Abad tunnel site in the Hormozgan province have been discussed. Considering that the tunnel site is located in an active tectonized environment in terms of geological conditions and the depth of the tunnel in some parts reaches more than 100 to 253 m, and also considering the variety of rocks in the tunnel site, which are massive rocks with high strength up to broken fault zones, the importance of studying and investigating the phenomenon of rock burst is very important for the safety of the labor force and equipment and the stability of the underground space. For this purpose, the Haji-Abad tunnel site has been divided into ten units of engineering geological conditions using the BGD method, which includes eight units T1 to T8 and two crashed zones Tf1 and Tf2. Then, using common experimental and semi-experimental methods, the phenomenon of rock burst in the tunnel site has been evaluated. In the experimental procedure, Goel et al.'s criterion was used, according to which the rock burst phenomenon does not occur in any of the tunnel units. Using semi-empirical methods, including the criterion of linear elastic energy of the tunnel site units in the range of very low to moderate rock burst phenomena and using the tangential stress criterion, the site units in the medium to very high range and based on the stress criteria of these units in the moderate to high range and finally, using the fragility criterion, all site units are placed in the range of high rock burst.
