Showing 2 results for Sadeghpour
Maryam Hadi, Rasol Ajalloeian, Amir Hossein Sadeghpour,
Volume 8, Issue 3 (12-2014)
Abstract
One way of reduction of leakage from beneath of earth dams is using of one contact clay layer with very low permeability and intermediate to high plastisity and connectig it to core of dam. Since, most of fine-grained soil in environtment of dam have low plastisity and preparing it from another place is not economic, use of bentonite in order to improvement of engineering characteristic of borrowed clay is suitable way.
In this search effect of bentonite on geotechnical properties of fine-grained soils with low plastisity are evaluated. Results of this research show that hydraulic conductivity, consolidation coefficient, dry density, colifornia bearing ratio (CBR),.....are decreased with increase in bentonite content but optimum moisture , Aterberg limits , cohession and so on are increased with bentonite addition. Finally, with analysis of obtained result, optimum percent of bentonite is offered in order to improve of engineering properties of used clay in contact region.
Mehdi Derakhshandi, Mojtaba Honarmand, Amir Hossein Sadeghpour,
Volume 16, Issue 1 (5-2022)
Abstract
Earth dams are geotechnical structures constructed on various shapes of a valley. The Vanyar Dam is a rock-fill dam located on a narrow valley. Concerning the geometry of the canyon, three-dimensional modeling was utilized to analyze this dam. According to the numerical analysis, the maximum settlement is 88.14 cm, which corresponds to 48 m above the bedrock in cross-section C, that is, a little less than 1% of the dam height. Besides, the total vertical stresses recorded by the pressure cells are about 28% less than those obtained from the numerical analysis. It is assumed that the difference is caused by local arching due to lower compaction and consequently a low stiffness area around the pressure cells. In terms of pore water pressure, there is good agreement between the pore water pressure obtained from the numerical analysis and the piezometers, such that the results are restricted to less than 1%. In general, the difference between the numerical analysis results and those recorded by the instruments is acceptable. Furthermore, the dam shows a suitable level of performance at the end of construction.
