XML Persian Abstract Print


Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:

Safarian Zengir V, Sobhani B. Investigating and predicting the hazardous effects of monthly Ferrin temperature on horticultural and agricultural products In the north bar of Iran (Golestan, Gilan and Mazandaran provinces). Journal of Spatial Analysis Environmental Hazards 2019; 5 (4) :125-144
URL: http://jsaeh.khu.ac.ir/article-1-2822-en.html
1- University of Mohaghegh Ardabili , v.safarian@uma.ac.ir
2- Faculty Member of the University of Mohaghegh Ardabili
Abstract:   (5171 Views)
Introduction
Changes, although low in temperature, change the occurrence of extreme phenomena such as droughts, heavy rainfall and storms (Varshavian et al., 2011: 169). Reducing the daily temperature variation has led to a reduction in the frequency of occurrence of temperature minima, especially in winter (Schiffinger et al., 2003, p. 51-41).
Material and method
The purpose of the present study was to investigate and predict the risk of monthly rainfed temperatures on horticultural and agricultural products in northern Iran. For this purpose, first, the data of the temperature of the whole station were obtained at a time interval of 30 years. Then, using Anfis's adaptive neural network model, data were collected for prediction and prediction for the next 6 years. Then, to measure the land suitability of the northern strip Iran was used for cultivating according to the predicted data using two models of Vikor and Topsis.
Conclusion:
In recent years, damage to agricultural and horticultural products has been increased due to temperature fluctuations. Accordingly, in this research, the prediction of the risk of monthly rainfed temperatures on horticultural and agricultural products in northern Iran has been investigated. Based on the predicted data, the minimum temperature of the Gorgan station was the lowest educational error with a value of 0.10 and at the maximum temperature, the lowest error was 0.015. Finally, in Golestan province, the maximum temperature And at least both are weak in the incremental state. Minimum and maximum temperature of Bandar Anzali station was the lowest educational error with the value (0.013, 0.10). In Gilan province, the maximum temperature peaks and at least both are in incremental conditions and the maximum temperature has a higher intensity. Be The minimum temperature of the Babolsar station was the lowest educational error with the value of 0.019 and at Ramsar maximum temperature, the lowest error was 0.016, and Mazandaran province exhibited maximum and minimum temperatures at both incremental and minimum levels Temperature showed greater intensity.
Results:
According to the findings of the study, with respect to the friction frain modeling, the maximum temperature showed the lowest defect compared to the minimum temperature. In Golestan province, the maximum temperature peaks and at least both are in weak increment, but in Gilan province, the maximum temperature peaks and at least both the maximum and maximum temperatures are higher. Mazandaran province showed maximum temperature and minimum temperature in both incremental and minimum temperature conditions.
 
Full-Text [DOCX 17 kb]   (1264 Downloads)    
Type of Study: Research | Subject: Special
Received: 2018/07/23 | Accepted: 2018/12/22 | Published: 2019/03/12

Add your comments about this article : Your username or Email:
CAPTCHA

Send email to the article author


Rights and permissions
Creative Commons License This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

© 2024 CC BY-NC 4.0 | Journal of Spatial Analysis Environmental hazarts

Designed & Developed by : Yektaweb